NEC Univerge SV9300 Series - Page 54

4. Select “ Protocol”.
Select one of the following operations.
• Highlight an item by using , and press
, or Soft key (OK).
•
Press
.
3
Server Address
4
Protocol
↑ ↓ Back OK
5. Select a Protocol type of the server
which stores the Backup file.
Select one of the following operations.
• Highlight
an item by using
, and press
or Soft key (OK).
•
Press
, or , and press or
Soft key (OK).
1
FTP
2
TFTP
↓ Back OK
The display goes back to the [Backup/
Restore] screen.
6. According to the selection in
[Protocol] screen, proceed to the
following steps below
.
• When “
FTP” is selected here, go to
Step 7.
•
When “
TFTP”
is selected here, go to
Step 15.
• When “
HTTPS” is selected here, go
to Step 7.
7. Select “
Account Settings”.
Select one of the following operations.
• Highlight
an item by using
, and press
, or Soft key (OK).
•
Press
.
5
Account Settings
↑ Back OK
8. Select “ User ID”.
Select one of the following operations.
• Highlight an item by using , and press
, or Soft key (OK).
•
Press
.
1
User ID
2
Password
↓ Back OK
9. Enter a User ID with digit keys.
Please refer to “APPENDIX B INPUT
CHARACTERS” on page
102 for how to
enter the character.
Input a user ID. A
BK Back OK
• Enter a User ID with digit keys, and
press or Soft key (OK).
The display goes back to the [Account
Settings] screen.
10. Select “ Password”.
Select one of the following operations.
• Highlight
an item by using
, and press
, or Soft key (OK).
•
Press
.
1
User ID
2
Password
↑ ↓ Back OK
11. Enter a password with digit keys.
Please refer to “APPENDIX B INPUT
CHARACTERS” on page
102 for how to
enter the character.
Input a password. A
BK Back OK
• Enter a password with digit keys, and
press or Soft key (OK).
The display goes back to the [Account
Settings] screen.
TERMINAL SETUP
46