Charging and Power
Your CyberScope Air includes a USB-C 15V/3A
power adapter.
WCAUTION: Only the NetAlly-supplied power
adapter is supported.
To begin charging the internal lithium-ion
battery, plug the included power adapter into an
AC outlet and the USB-C charging port on the
left side of the unit. The Status LED blinks red
when the unit is off and charging and turns solid
red at full charge. Refer to the Specifications for
battery run duration and charge times.
Powering On
l
To start up the unit, hold down the Power
Button for approximately one second, until
the Status LED turns green.
l
When the display goes into Sleep mode, the
Status LED blinks green to indicate the
battery level. Tap the Power Button briefly to
wake up the display. (Set the timing for
display sleep and auto power off in the
Device Settings.)
Introduction
25