Running Ping/TCP Tests
Your unit must be connected to an active
network (Test or Management Port) to run Ping
and TCP Connect tests. Icons in the top Status
Bar indicate whether and how your CyberScope
Air is connected. See Connection Notifications
for descriptions of the connection status icons,
and select the appropriate Interface (or Any
Port) from the Ping/TCP settings.
The default target is google.com. Open the app
settings to enter a new target.
To begin the test, tap START.
If the Number of Tests setting is set to
Continuous, the Ping/TCP app runs tests to your
selected target until you tap STOP.
Ping/TCP Test App
639
To Next Page
Loading...
Need help?
General
