Test Ports
Wi-Fi Test Port: The internal Wi-Fi test
adapter is a 2x2 Tri-band 802.11ax wireless
radio. (To disable, see General Settings in the
testing apps' left-side navigation drawer.)
CyberScope Air runs Wi-Fi AutoTests, Captures,
Discovery, and other comprehensive network
analysis apps over the test port. The Wi-Fi test
radio is primarily controlled by the settings in
applications, especially AutoTest.
You use the AutoTest app to set up and run an
AutoTest Wi-Fi Profile to establish a link on the
Wi-Fi test port. (By default, the CyberScope Air
starts in the Wi-Fi App passive scanning mode).
Note that the General Settings affect how you
can use the test port. (The General Settings are
accessible from the left-side navigation drawer
from most NetAlly testing apps.)
General Settings and Tools
77