Gateway Test
To disable the Gateway test in your current
AutoTest, tap the top field on the this screen to
set it to Disabled. The Gateway card still appears
on the main AutoTest results screen so that you
can still see the addresses of the Gateway
servers. However, the following lookup values
are set to "--", and the Result Code is set to
“Test is disabled”.
Timeout Threshold
The only other setting for the Gateway Test is
the timeout threshold, which indicates how long
the AirCheck G3 waits for a response from the
gateway before grading the test as a fail. Tap the
field to select one of the value options, or enter
a custom value.
Reverse Grading
When Reverse Grading is enabled, a test is
considered successful if it fails and a failure if it
succeeds. The Results Codes section of the
results screen includes the message "Grading
has been reversed".
AutoTest App and Profiles
261
To Next Page
Loading...