for a passive survey:
1. Before beginning the survey, use AutoTest to
run a Wi-Fi profile that connects to the
desired SSID.
2. Tap START to begin the survey. If you did
not start the AutoTest profile or if the test is
still in progress, a message displays at the
bottom of the screen, and the survey cannot
start.
3. Collect data as you would a passive survey,
as described above.
o
If the connection is lost (such as by
roaming out of range or a signal
blockage), the link notification changes
to an X. AutoTest continuously tries to
reconnect to the SSID.
Survey points taken during this unlinked
time are displayed in yellow to indicate
areas where there is not coverage for
that SSID.
o
You can check the Wi-Fi connection in
several ways during your survey:
AirMapper™ App
588
To Next Page
Loading...