NetApp AltaVault AVA400 - Managing licenses

NetApp AltaVault Cloud Integrated Storage Administration Guide 115
Managing licenses Managing the AltaVault appliance
3. Under Details for Job <#>, complete the configuration as described in this table.
4. Click Apply Changes to save your settings permanently.
Managing licenses
There are four types of license keys (AVA-v2, AVA-v8, AVA-v16, AVA-v32) and are only required for the AltaVault
virtual models. CPU, memory, disk, and cloud capacity enforcement is based on the license applied.
Note: You can install only one license key at a time.
To add or remove a license requires the optimization service to be shutdown in order to allow it to perform capacity
and usage checks at the time of starting up. Choose Maintenance > Service to shut down the service.
If an attempt is made to configure license while service is running the following message will appear in the CLI:
Cannot configure license while optimization service is running
Managing licenses includes the following sections:
 “Managing unlicensed AltaVault appliances” on page 116
 “Managing licenses using the command-line” on page 116
 “Managing licenses using the Management Console” on page 117
 “License limits” on page 117
 “Model upgrades on the virtual AltaVault appliances” on page 117
Control Description
ID Specify the job ID number.
Name Specify a name for the job.
Comment Add any comments.
Interval Specify the recurrence interval in seconds
Executes On Specify the date on which the job runs.
Created Specify the date and time at which the job was created.
Last Run Specify the last date and time at which the job was executed.
Enable/Disable Job Enables the job.
Apply Changes Applies the changes to the current configuration.
This Job s the job.
Execute Now Runs the job.
Remove Selected Jobs Select the check box next to the name and click Remove Selected Jobs.