NetApp AltaVault Cloud Integrated Storage Administation Guide 53
Beta Draft
Modifying management interfaces Modifying networking settings
3. Click Apply to apply your changes to the running configuration.
The proxy settings do not affect cloud connections originating from the AltaVault.
Modifying management interfaces
You can view and modify settings for the appliance interfaces in the Management Interfaces page. Use the following
groups of controls on this page only if you require modifications or additional configuration:
Primary Interface - The primary interface is the interface used to manage the device. It is the interface utilized to
get to the Management Console and command-line interface (CLI). This is also the default port used for
replication if no other interface is set up for replication traffic as described in “Configuring bandwidth limits” on
page 36.
Main IPv4 Routing Table - Displays a summary of the main routing table for the appliance. You can add static
routes that might be required for some subnets.
To display and modify the configuration for management interfaces
1. Choose Configure > Management Interfaces.
2. Under Primary Interface, complete the configuration as described in this table.
Port Optionally, specify the port for the Web or FTP proxy. The default port is 1080.
Enable Authentication Optionally, select to require user credentials for use with Web or FTP proxy traffic.
Specify the following settings to authenticate the users:
• User Name - Specify a username.
• Password - Specify a password.
• Authentication Type - Select an authentication method from the drop-down list:
– Basic - Authenticates user credentials by requesting a valid username and
password. This is the default setting.
– NTLM - Authenticates user credentials based on an authentication challenge and
response.
– Digest - Provides the same functionality as Basic authentication; however, Digest
authentication improves security because the system sends the user credentials
across the network as a Message Digest 5 (MD5) hash.
Control Description
Enable Primary Interface Enables a primary interface for the AltaVault.
If only one interface is set up, both appliance management and replication traffic will
traverse it.
Obtain IPv4 Address Automatically Automatically obtain an IPv4 address from a DHCP server.
• Enable IPv4 Dynamic DNS - Select this option to enable IPv4 dynamic DNS on the
primary interface.
Control Description
To Next Page
Loading...
