NetApp AltaVault Cloud Integrated Storage Administration Guide 17
Beta Draft
CHAPTER 3 Using the AltaVault configuration
wizards
This chapter includes the following sections:
“Using the AltaVault appliance CLI configuration wizard” on page17
“Using the Management Console” on page 18
“Using the Wizard Dashboard” on page 20
Using the AltaVault appliance CLI configuration wizard
After installing the AltaVault appliance and logging in for the first time, you are prompted to enter initial system
information using command-line interface (CLI).
To run the AltaVault appliance CLI configuration wizard
1. Complete the configuration wizard steps on the client side and server side.
Wizard prompt Description Example
Step 1: Admin password? NetApp requires that you change the default
administrator password (
password) at this time.
The new password must be a minimum of eight
characters and cannot be the word password.
Step 1: Admin password?
xxxxyyyy
Step 2: Host name? Enter the host name for the AltaVault appliance. Step 2: Hostname? amnesiac
Step 3: Use DHCP on the
primary interface?
For AltaVault virtual and physical appliances,
DHCP is not recommended. For AltaVault cloud-
based virtual appliances, DHCP is required.
Step 3: Use DHCP? yes
Step 4: Primary IP address? Enter the IP address. Step 4: Primary IP address?
10.10.10.6
Step 5: Netmask? Enter the netmask address. Step 5: Netmask? 255.255.0.0
Step 6: Default gateway? Enter the default gateway. Step 6: Default gateway?
10.0.0.1
To Next Page
Loading...
