NetApp AltaVault Cloud Integrated Storage Administration Guide 47
Beta Draft
Configuring SnapMirror Configuring storage settings
To edit OST user
1. Extend the user name to complete the configuration as described in this table.
Configuring SnapMirror
AltaVault supports backup and restore operations for ONTAP FlexVol volumes using the SnapMirror service. Backup
relationships are created and managed from ONTAP using ONTAP commands or SnapCenter software. SnapMirror
support is available on AltaVault physical and virtual appliance models. For more information about SnapMirror
operation with ONTAP, see the
Data Fabric Solution for Cloud Backup resource page.
This section includes the following topics
“Enabling SnapMirror service” on page 47
“Monitoring and deleting SnapMirror shares and Snapshots on AltaVault” on page 48
“Enabling long-term retention” on page 49
“Enabling SnapCenter access” on page 50
Enabling SnapMirror service
To enable SnapMirror service
1. Choose Configure > SnapMirror in the Management Console.
2. Under SnapMirror Service, click Enable.
3. If the “Service restart required” prompt appears, click the Restart button that becomes enabled in the upper right
portion of the AltaVault Management Console.
4. Under Whitelist IP, click Add Whitelist IP.
The Whitelist specifies which addresses are authorized to communicate with AltaVault.
5. Enter the IP addresses of ONTAP intercluster LIFs from which AltaVault will accept connections for backup and
restore operations, and click Add.
Control Description
Change Password Select the check box to change the password.
Password Specify the new password.
Password Confirm Re-enter the new password.
Account Specify:
• Enabled - Enables local user account
• Disabled - Disables local user account
Apply Applies the changes to the OST share users.
To Next Page
Loading...
