NetApp AltaVault Cloud Integrated Storage Administration Guide 95
Beta Draft
Configuring KMIP Configuring security settings
To configure cloud settings
1. Choose Configure > Cloud Settings.
2. Select Cloud tab.
3. Select your cloud provider.
4. Select Yes from the Use Keys from KMIP Server drop-down list.
5. Select the correct secret data object names for each cloud authentication parameter (Access Key and Secret Key).
6. Click Apply to save your settings.
7. Select Maintenance > Service, and select Start to start the Storage Optimization Service.
To configure the encryption key
1. Choose Configure > Cloud Settings.
2. Select Encryption tab.
3. Select yes from the drop-down list.
4. Select the symmetric key name that corresponds to the AES-256 key.
Using CLI to configure KMIP
You can use CLI to configure KMIP. For more information, see the NetApp AltaVault Cloud Integrated Storage
Command-Line Reference Guide available on the NetApp Support at https://mysupport.netapp.com
under the
Documentation tab.
Troubleshooting KMIP
KMIP commands are normally used by the AltaVault to the KMIP server in two situations: when the service comes up
(most common) and when an object is registered with the server. Activity from these actions are recorded by AltaVault
in the Maintenance > System Logs page.
Add Adds the KMIP keys to the AltaVault. The KMIP key displays in the table below.
Remove Selected Select a KMIP key and click Remove Selected to delete.
Control Description
To Next Page
Loading...
