NetApp AltaVault Cloud Integrated Storage Administration Guide 157
Beta Draft
Viewing the verify tool diagnostics Viewing reports and logs
To set the file system check duration using the CLI
In some cases, file system checking can impact overall utilization of system resources. You can manage system
utilization for file system checks by setting the duration in the CLI. For example, setting a longer duration extends the
amount of time over which file system checks are done, reducing system utilization for a given time.
1. To change the file system check duration, enter the following command:
hostname (config)# datastore integrity check duration <duration>
Set the duration from 1 to 60 days. The default duration is 30 days. The setting takes effect in the next check
cycle.
Viewing the verify tool diagnostics
The Verify page provides the diagnosis for checking cloud replication consistency. Start the Verify operation only after
all pending replication has completed successfully and the value of Replication Bytes Pending is zero.
You cannot run the Verify tool if the storage optimization service is running.
To view the Verify tool diagnostics
1. Choose Maintenance > Replication Verify Check.
2. Click the filename to open a Verify log file or save the file to disk.
3. Under Actions, complete the configuration as described in this table.
4. Open and check the Verify log file. If all data in the local disk is replicated in the cloud, the file displays the
following result:
Verification complete: collection is properly replicated.
Otherwise, the log file displays an error message.
Control Description
Status Displays the status of the Offline File System Check report, such as
running or not running.
Only validate checksums Click this option to verify only the checksums.
Start Starts the Verify tool.
Stop Stops the Verify tool.
To Next Page
Loading...
