NetApp AltaVault AVA400 - Using the import configuration wizard

NetApp AltaVault Cloud Integrated Storage Administration Guide 33
Beta Draft
Using the Wizard Dashboard Using the AltaVault configuration wizards
2. After you configure a private cloud using the CLI, it appears in the Cloud Settings page and the dashboard in the
Cloud Information section as the Provider. For more information on CLI, see the NetApp AltaVault Cloud
Integrated Storage Command-Line Interface Reference Guide.
3. Choose Configure > Cloud Settings.
4. Select the Cloud tab.
5. Under Cloud Provider Settings, complete the configuration as necessary. Refer to your private cloud configuration
for the required authentication credentials needed to communicate with this cloud.
Using the import configuration wizard
Use the Import Configuration wizard to import a previously saved configuration into the AltaVault. The Import
Configuration Wizard will fail if the AltaVault already has an encryption key set.
It is recommended to set the time zone to the AltaVault prior to uploading the configuration.
To use the import configuration wizard
1. From the management console, choose Configure > Setup Wizard.
2. Select Import Configuration in the Wizard Dashboard.
3. Select one of the following options:
 Select Local File and click Browse to select a local configuration file from your computer.
-or-
 Select URL and specify the URL of an appliance whose configuration you want to import.
4. Leave the Import Shared Data Only check box selected to import only the following common settings:
 Cloud settings
 Email settings
 Logging
 NTP settings
 SNMP settings
 Statistics or Alarms settings
 Time zone settings
 Web and CLI preferences
 SMB, NFS, OST, SnapMirror configuration
When you select the Import Shared Data Only check box, the following settings are not imported:
 General Security Settings
 Static host configuration
 Appliance licenses
 Interface configuration, IP configuration, static routes, and virtual interfaces.