54 NetApp AltaVault Cloud Integrated Storage Administation Guide
Beta Draft
Modifying networking settings Modifying data interfaces
3. Click Apply to apply your changes to the running configuration.
To modify main IPv4 routing table
1. Choose Configure > Management Interfaces.
2. Under Main IPv4 Routing Table, complete the configuration as described in following table.
.
3. Click Apply.
You can verify whether changes have had the desired effect by reviewing related reports.
Modifying data interfaces
You can view and modify settings for the data interfaces in the Configure > Data Interfaces page.
To display and modify the configuration for data interfaces
1. Choose Configure > Data Interfaces.
Specify IPv4 Address Manually Specify this option to set a static IP address.
• IPv4 Address
- Specify an IPv4 address.
• IPv4 Subnet Mask
- Specify an IPv4 subnet mask.
• Default IPv4 Gateway
- Specify the default primary gateway IPv4 address. The
primary gateway must be in the same network as the primary interface.
MTU Specify the Maximum Transmission Unit (MTU) value. The default value is 1500.
Control Description
Add a New Route Displays the controls for adding a new route.
Destination IPv4 Address Specify the destination IPv4 address for the appliance.
IPv4 Subnet Mask Specify the IPv4 subnet mask.
Gateway IPv4 Address Specify the IPv4 address for the gateway.
Interface Select the interface from the drop-down list.
Add Adds the route to the table list.
Remove Selected Select the check box next to the name and click Remove Selected.
Control Description
To Next Page
Loading...
