NetApp AltaVault AVA400 - Page 55

NetApp AltaVault Cloud Integrated Storage Administation Guide 55
Beta Draft
Modifying data interfaces Modifying networking settings
2. Under Physical Interface, click the arrow next to the name of the interface and complete the configuration as
described in this table.
.
If a physical interface is a member of a virtual interface, it is owned by the virtual interface and you can only
enable it by editing the virtual interface.
3. Under Routing Table for <physical interface>, you can configure static routes if your network requires them.
You can add or remove routes from the table as described in following table.
.
4. Under Virtual Interface, click the arrow next to the name of the interface to enable and configure the VIF
networking configuration. Create virtual interfaces from the Configure > VIFs page.
.
Control Description
Enable Data Interface Select the check box to enable the data interface and specify the following settings:
• IPv4 Address
- Specify an IPv4 address.
• IPv4 Subnet Mask
- Specify a subnet mask.
• IPv4 Gateway
- Specify the gateway IP address.
• MTU - Specify the MTU value. The default value is 1500.
Control Description
Add a New Route Displays the controls for adding a new route.
Destination IP Address Specify the destination IP address for the appliance.
Subnet Mask Specify the subnet mask.
Gateway IP Address Specify the IP address for the gateway.
Add Adds the route to the table list.
Remove Selected Select the check box next to the name and click Remove Selected.
Control Description
Virtual Interface Displays the controls to add a virtual network interface.
IP Configuration Displays the IP address of the network interface.
Enabled Displays the state of the interface.
Members Specify a comma-separated list of the data interfaces that are members of this VIF.
Enable Data Interface Select this check box to enable the data interface and specify the following settings:
• IPv4 Address
- Specify an IPv4 address.
• IPv4 Subnet Mask
- Specify a subnet mask.
• IPv4 Gateway
- Specify the gateway IP address.
• MTU - Specify the MTU value. The default value is 1500.