56 NetApp AltaVault Cloud Integrated Storage Administation Guide
Beta Draft
Modifying networking settings Modifying virtual interfaces (VIFs)
5. Under VLAN Interface, click the arrow next to the name of the interface to complete the configuration. Create
virtual interfaces from the Configure > VLANs page.
.
If an interface is a member of a virtual interface, you can only enable it by editing the virtual interface.
6. Under Routing Table for <VLAN interface>, you can configure static routes if your network requires them.
You can add or remove routes from the table as described in following table.
.
7. Click Apply to save your changes.
Modifying virtual interfaces (VIFs)
You can view, add and modify virtual interfaces (VIFs) in the Configure > VIFs page. A VIF is a logical bonded
interface created by aggregating multiple physical interfaces.
To display, add, and modify the VIF configuration
1. Choose Configure > VIFs.
2. Click Add a Virtual Interface and complete the configuration as described in this table.
Control Description
IP Configuration Displays the IP address of the network interface.
Enabled Displays the state of the interface.
Enable Interface Select the check box to enable the data interface and specify the following settings:
• IPv4 Address
- Specify an IPv4 address.
• IPv4 Subnet Mask
- Specify a subnet mask.
• IPv4 Gateway
- Specify the gateway IP address.
• MTU - Specify the MTU value. The default value is 1500.
Control Description
Add a New Route Displays the controls for adding a new route.
Destination IP Address Specify the destination IP address for the appliance.
Subnet Mask Specify the subnet mask.
Gateway IP Address Specify the IP address for the gateway. The gateway must be in the same network as the
network interface you are configuring.
Add Adds the route to the table list.
Remove Selected Select the check box next to the name and click Remove Selected.
Control Description
Enable VIF Enables VIF feature.
Virtual Interface Name Specify a name for the virtual interface.
Member Interfaces Specify a comma-separated list of the data interfaces that are members of this VIF.
To Next Page
Loading...
