172 NetApp AltaVault Cloud Integrated Storage Administration Guide
Beta Draft
Migrating data between appliances Data migration process
Data migration process
The data migration process has multiple high-level steps as described in the following table:
Prerequisites
The following describes the prerequisites required of the source and target appliances prior to performing data
migration.
“Prerequisites for the source appliance” on page 173
“Prerequisites for the target appliance” on page 174
Steps Details
Validate prerequisite steps for
source and target appliances
For more information, see “Prerequisites” on page 172.
Install the new AltaVault target
appliance
For information on the procedure, see the current version of the NetApp AltaVault
Cloud Integrated Storage Installation Guide for the Virtual Appliances or AltaVault
System Installation and Setup Instructions (poster)
Connect the source appliance to
the target appliance
For more information, refer to the suggested network diagram configurations as
shown in the “Data migration connection diagrams” on page 170.
Run the migration tool to
migrate data on to the target
appliance
For more information on how to migrate, see “Performing appliance data migration”
on page 174.
Bring up the new appliance For details, see “Post-data migration procedure” on page 176.
Decommission the source
appliance
The source appliance needs to be decommissioned according to your company’s
practices regarding decommissioned hardware. If the source appliance will be reset
and used in a new data protection capacity, contact NetApp support for assistance on
steps needed to redeploy the appliance.
To Next Page
Loading...
