22 NetApp AltaVault Cloud Integrated Storage Administration Guide
Beta Draft
Using the AltaVault configuration wizards Using the Wizard Dashboard
4. Click Next to display the Confirmation page.
5. Click Save and Apply to display the System Settings Wizard Finish page.
6. Click Exit to close the System Settings Wizard and go back to the dashboard.
Using the Cloud Settings wizard
Use the Cloud Settings wizard to configure cloud settings, licensing, and the encryption key.
To use the Cloud Settings wizard
1. From the management console, choose Configure > Setup Wizard.
2. Select Cloud Settings in the Wizard Dashboard.
Note: Check that the datastore is empty. If the datastore is not empty, you cannot change the cloud provider, region, hostname, and
bucket name.
3. Under Provider, select and configure your preferred cloud service provider from the drop-down list:
Note: If you are configuring a private cloud, see “Customizing a private cloud” on page 32.
Amazon Glacier - see “Configuring Amazon Glacier storage” on page 24
Amazon S3 - see “Configuring Amazon S3 storage” on page 26
AT&T Synaptic Storage - see “Configuring Atmos-based storage” on page 26
Cleversafe Cloud Storage - see “Configuring S3-based storage” on page 30
Cloudian Cloud Storage - see “Configuring S3-based storage” on page 30
Cloudwatt Object Storage - see “Configuring SWIFT-based storage” on page 30
Dunkel Cloud Storage - see “Configuring S3-based storage” on page 30
EMC Atmos- see “Configuring Atmos-based storage” on page 26
Specify IPv4 Address Manually Specify this option if you do not use a DHCP server to set the IP address. Specify the
following settings:
• IPv4 Address - Specify an IPv4 address.
• IPv4 Subnet Mask
- Specify an IPv4 subnet mask.
• Default IPv4 Gateway
- Specify the default primary gateway IPv4 address. The
primary gateway must be in the same network as the primary interface. You must set
the primary gateway for interface configurations.
Time Zone Specify the country and time zone in which the AltaVault is located.
Enable Analytics Enabling this feature will send daily informational AutoSupport (ASUP) messages to
NetApp.
Control Description
To Next Page
Loading...
