202 NetApp AltaVault Cloud Integrated Storage Administration Guide
Beta Draft
System maintenance AVA-400, AVA-800 Accessing the Service Processor for remote management
Netmask:255.255.255.0
Gateway:172.16.100.1
IPv6: Disabled
5. After the Service Processor is configured, run the autoboot command at the LOADER prompt to start the
AltaVault appliance:
LOADER-A> autoboot
Validating remote access via the Service Processor
The following commands show an example of how to validate the remote access using the SP.
1. Connect to the Service Processor using one of the following methods:
Connect to the serial console port and log in to the AltaVault. Press Ctrl+G to get into Service Processor
mode. To exit service processor mode, press Ctrl+D.
SSH to the IP address of the Service Processor. Log in using the password set previously.
2. Obtain the Service Processor IP configuration and firmware version:
SP> sp status
Firmware Version: 3.0.2
Debug Mode: Enabled
Mgmt MAC Address: 00:A0:98:65:03:24
Ethernet Link: Up, 1000Mb, Full-Duplex, Auto-neg enabled,completed
Using DHCP: no
IPv4 configuration:
IP Address: 172.16.33.154
Netmask: 255.255.240.0
Gateway: 172.16.33.1
IPv6 configuration: Disabled
3. Enter the following IPMI command to test the Service Processor feature:
SP> system sensors
Sample output (truncated):
To Next Page
Loading...
