NetApp AltaVault Cloud Integrated Storage Administration Guide 201
Beta Draft
Accessing the Service Processor for remote management System maintenance AVA-400, AVA-800
To setup the Service Processor for remote management
1. Log in to the CLI using the serial console connection.
2. At the CLI prompt, reboot the appliance and interrupt the AUTOBOOT process by pressing CTRL + C. This halts
the appliance at the LOADER prompt.
(config) # reload
Rebooting...
.....
.....
Starting AUTOBOOT press Ctrl-C to abort...
****Hit CTRL+C****
Autoboot of PRIMARY image aborted by user.
LOADER-A>
3. At the LOADER prompt, enter the command, sp setup, to setup the IP address for the Service Processor.
LOADER-A> sp setup
4. Based on your setup, choose one of the following:
To enable DHCP, enter the following:
LOADER-A> sp setup
Would you like to configure the SP? [y/n] y
Would you like to enable DHCP on the SP LAN interface? [y/n] y
Do you want to enable IPv6 on the SP? [y/n] n
Output sample:
Service Processor New Network Configuration
Ethernet Link: up, full duplex, auto-neg complete
Mgmt MAC Address: 00:A0:98:54:F9:F6
IPv4 Settings
Using DHCP: YES
IP Address: 172.16.33.154
Netmask: 255.255.252.0
Gateway: 172.16.33.1
IPv6: Disabled
Note: Make a note of the IP address. It is used to validate remote access via the Service Processor.
If you do not want to enable DHCP, enter the IP address, netmask, and gateway address from the command
line. The IP address of the SP interface must be on the same subnet as the primary interface. The SP interface
and primary interface are connected to the wrench port on the AltaVault by means of an internal switch.
Would you like to configure the SP? [y/n] y
Would you like to enable DHCP on the SP LAN interface? [y/n] n
Please enter the IP address for the SP [unknown]: 172.16.100.4
Please enter the netmask for the SP [unknown]: 255.255.255.0
Please enter the IP address for the SP gateway [unknown]: 172.16.100.1
Do you want to enable IPv6 on the SP? [y/n] n
Output sample:
Service Processor New Network Configuration
Ethernet Link: up, full duplex, auto-neg complete
Mgmt MAC Address: 00:A0:98:5D:34:BC
IPv4 Settings
Using DHCP:NO
IP Address:172.16.100.4
To Next Page
Loading...
