NetApp AltaVault Cloud Integrated Storage Administration Guide 231
Beta Draft
APPENDIX A Administrator’s configuration
worksheet
Configuration worksheet
1 Appliance information Notes
1.1 Appliance host name: This is the name of the appliance and needs to
be configured in DNS as well.
1.2 IP address for Primary Interface: This IP address is required for
configuring the PRI (Primary) / Management Interface when the CLI
wizard runs automatically during the initial deployment. It is
recommended to use a static IP address.
1.3 Netmask
1.4 Primary DNS server IP
1.5 NTP Server
1.6 FQN and IP address of SMTP Relay Server: This is required to
configure and enable email notifications.
1.7 Email address or alias for Notification of Events and Failures: There
are two groups of notifications - “Events” Group and “Failure” Group.
1.8 Domain name for the appliance: This needs to be configured in DNS
as well to resolve fqdn of the appliance.
1.10 Time zone in which the appliance will be installed
2 Cloud provider credentials and storage configuration Notes
2.1 Name of Preferred Cloud Provider: For example, AWS etc. The
information required to configure the cloud provider is dependent on
the specific cloud provider you have selected.
2.2 Region: The information required to configure the cloud provider is
dependent on the specific cloud provider you have selected.
2.3 Credentials to Cloud Object Storage: For example, Amazon S3 access
and secret key.
2.4 Bucket name: The bucket name must be unique (across all of AWS).
To Next Page
Loading...
