232 NetApp AltaVault Cloud Integrated Storage Administration Guide
Beta Draft
Administrator’s configuration worksheet Configuration worksheet
2.5 Is connectivity to cloud, in place - Yes/No? Connectivity to the cloud
is mandatory in order for the appliance to be configured. WAN
circuits, firewalls (port 443) etc. must be configured prior to
commencing configuration. If not when will it be in place?
2.6 Bandwidth to cloud.
2.7 Port value (typically 443)?
2.8 Cloud CA Certificate (if using private cloud): .pem file for private
cloud provider
2.9 Encryption key: If you import from another AltaVault appliance, have
key file or contents and key passphrase available (if required).
2.10 Replication interface - Replication interface defaults to the Primary
interface unless another interface is selected and configured.
2.11 Number of shares to be created on the AltaVault appliance.
2.12 SMB Share Name(s) / naming convention to be used: Specify the
share name(s) to be configured or whether any naming convention is
to be followed.
2.13 SMB Domains: Will the AltaVault appliance be part of AD Domain?
Yes / No .
If Yes, Domain administrator credentials will be required to join the
AD Domain.
2.14 Preferred domain controllers - specify up to three domain controllers
2.15 SMB Username(s) / Groups to be given access to the share,
2.16 NFS Export Name / naming convention to be used,
2.17 Is NFSv4 Kerberos required? If yes, Kerberos keytab and conf files
are required.
2.18 OST Share Name(s) / naming convention to be used: Specify the share
name(s) to be configured or whether any naming convention is to be
followed.
2.19 OST Username(s) to be given access to the share,
2.22 SnapMirror Whitelist - IP addresses from which Snapshots will be
allowed
3 Network connectivity Notes
3.1 Number of 1gbE/10GbE Data Interfaces to be used?
3.2 Specify speed of Data (Backup) LAN - 1Gbe or 10Gbe? Specify if the
Data LAN is be 1gb or 10gb NICs. AltaVault Appliance supports
4x1gb and 4x10gb NICs. IP addresses will be required for each port
depending on type of NIC supplied (4x1gb or 4x10gb).
3.3 Describe the LAN topology for Backup Data to the Appliance:
Flat LAN or VLANs.
3.4 Will Data Interfaces be connected to different subnets / VLANs?
AltaVault supports VLAN tagging. Note the VLAN IDs associated
with each data interface.
2 Cloud provider credentials and storage configuration Notes
To Next Page
Loading...
