68 NetApp AltaVault Cloud Integrated Storage Administration Guide
Beta Draft
Configuring system administrator settings Configuring SNMP basic settings
Enterprise Management Information Base (MIB)
ACLs (Access Control Lists) for users (v1 and v2c only)
To set general SNMP basic parameters
1. Choose Configure > SNMP Basic.
2. Under SNMP Server Settings, complete the configuration as described in this table.
3. Click Apply to apply your changes to the running configuration.
To add or remove a trap receiver
1. Under Trap Receivers, complete the configuration as described in this table.
Control Description
Enable SNMP Traps Enables event reporting to an SNMP entity.
System Contact Specify the username for the SNMP contact.
System Location Specify the physical location of the SNMP system.
Read-Only Community
String
Specify a password-like string to identify the read-only community. For example, public. This
community string overrides any VACM settings.
Community strings do not allow non-printable 7-bit ASCII characters, except for spaces. Also, the
community strings cannot begin with '#' and '-'.
Control Description
Add a New Trap Receiver Displays the controls to add a new trap receiver.
Receiver Specify the destination IP address or hostname for the SNMP trap.
Destination Port Specify the destination port.
Receiver Type Select SNMP version v1, v2c, or v3 (user-based security model).
Note: SNMP v1 and v2c are less secure, v3 is recommended.
Remote User (Appears only when you select v3). Specify a remote username.
Authentication (Appears only when you select v3). Optionally, select either Supply a Password or Supply a
Key to use while authenticating users.
Authentication Protocol (Appears only when you select v3). Select an authentication method from the drop-down
list:
• MD5 - Specifies the Message-Digest 5 algorithm, a widely used cryptographic hash
function with a 128-bit hash value. This is the default value.
• SHA - Specifies the Secure Hash Algorithm, a set of related cryptographic hash
functions. SHA is considered to be the successor to MD5.
Password/Password Confirm (Appears only when you select v3 and Supply a Password). Specify a password. The
password must have a minimum of eight characters. Confirm the password in the Password
Confirm text box.
To Next Page
Loading...
