100 | Chapter 7. OSPF
ProSafe 7000 Managed Switch Release 8.0.3
8. Enable OSPFv3 on interface 1/0/13, and set the OSPF network mode to broadcast.
(Netgear Switch) (Interface 1/0/13)#ipv6 ospf
(Netgear Switch) (Interface 1/0/13)#ipv6 ospf network broadcast
(Netgear Switch) #show ipv6 ospf neighbor
Router ID Priority IntfID Interface State DeadTime
-------- -------- ------ --------- --------- ----
1.1.1.1 1 1 1/0/13 Full/ DR 34
Web Interface: Configure OSPFv3
1. Enable IPv6 unicast routing on the switch.
a. Select Routing > IPv6 > Basic > IPv6 Global Configuration. A screen similar to the
following displays.
b. For IPv6 Unicast Routing Mode, select the Enable radio button.
c. Click Apply to save the settings.
2. Specify the router ID, and enable OSPFv3 for the switch.
a. Select Routing > OSPFv3 > Basic > OSPFv3 Configuration. A screen similar to the
following displays.
b. Under the OSPF Configuration, enter the following information:
• In the Router ID field, enter 1.1.1.1.
• For Admin Mode, select the Enable radio button.
c. Click Apply to save the settings.
3. Enable IPv6 on port 1/0/1.
To Next Page
Loading...
