Chapter 19. SNMP | 329
ProSafe 7000 Managed Switch Release 8.0.3
Time-Based Sampling of Counters with sFlow
CLI: Configure Time-Based Sampling of Counters with sFlow
1. Configure the sampling port sFlow receiver index, and polling interval. You need to
repeat this for all the ports to be polled.
(Netgear Switch) (Config)# interface 1/0/1
(Netgear Switch) (Interface 1/0/1)# sflow poller 1
(Netgear Switch) (Interface 1/0/1)# sflow poller interval 300
2. View the polling port configurations.
(GSM7328S) #show sflow pollers
Poller Receiver Poller
Data Source Index Interval
----------- --------- ---------
1/0/1 1 300
Web Interface: Configure Time-Based Sampling of Counters
with sFlow
1. Configure thesampling ports sFlow receiver index, and polling interval.
a. Select Monitoring > sFlow > Advanced > sFlow Interface Configuration.
b. Select the Interface 1/0/1 check box.
c. In the Poller Interval field, enter 300. A screen similar to the following displays.
d. Click Apply.
To Next Page
Loading...
