NETGEAR GSM7228PS - Configure Logging for a Port

300 | Chapter 17. Syslog
ProSafe 7000 Managed Switch Release 8.0.3
Web Interface: Show Logging Hosts
Select Monitoring > Logs > Sys Log Configuration. A screen similar to the following
displays.
Configure Logging for a Port
The example is shown as CLI commands and as a Web interface procedure.
CLI: Configure Logging for the Port
(Netgear Switch Routing) #config
(Netgear Switch Routing) (Config)#logging ?
buffered Buffered (In-Memory) Logging Configuration.
cli-command CLI
Command
Logging Configuration.
console Console Logging Configuration.
host Enter IP Address for Logging Host
syslog Syslog Configuration.
(Netgear Switch Routing) (Config)#logging host ?
<hostaddress> Enter
Logging
Host IP Address
reconfigure Logging Host Reconfiguration
remove Logging Host Removal
(Netgear Switch Routing) (Config)#logging host 192.168.21.253 ?
<cr> Press Enter to execute the command.
<port> Enter Port Id