EasyManua.ls Logo

NETGEAR GSM7228PS - CLI: Configure DVMRP

NETGEAR GSM7228PS
486 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
458 | Chapter 29. DVMRP
ProSafe 7000 Managed Switch Release 8.0.3
multicast streams are sent from the multicast resource to the host along the path built by
DVMRP.
192.168.1.0/24
1/0/1
1/0/21
192.168.5.0/24
192.168.3.0/24
1/0/11
1/0/24 1/0/3
1/0/13
1/0/13
192.168.4.0/24
192.168.4.0/24
Switch A
Switch C
Switch B
Host
Multicast
resource
1/0/20
Figure 1. DVMRP
CLI: Configure DVMRP
DVRMP on Switch A
1. Create routing interfaces 1/0/1, 1/0/13, and 1/0/21.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#routing
(Netgear Switch) (Interface 1/0/1)#ip address 192.168.1.1 255.255.255.0
(Netgear Switch) (Interface 1/0/1)#exit
(Netgear Switch) (Config)#interface 1/0/13
(Netgear Switch) (Interface 1/0/13)#routing
(Netgear Switch) (Interface 1/0/13)#ip address 192.168.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/13)#exit
(Netgear Switch) (Config)#interface 1/0/21
(Netgear Switch) (Interface 1/0/21)#routing
(Netgear Switch) (Interface 1/0/21)#ip address 192.168.3.2 255.255.255.0
(Netgear Switch)(Interface 1/0/21)#exit
2. Enable IP multicast forwarding on the switch.
(Netgear Switch) (Config)#ip multicast

Table of Contents

Other manuals for NETGEAR GSM7228PS

Related product manuals