NETGEAR GSM7228PS - Stub Areas

Chapter 7. OSPF | 75
ProSafe 7000 Managed Switch Release 8.0.3
• In the Priority field, enter 255.
• In the Metric Cost field, enter 64.
c. Click Apply to save the settings.
8. Enable OSPF on port 1/0/4.
a. Select Routing > OSPF > Advanced > Interface Configuration. A screen similar to
the following displays.
b. Under Interface Configuration, scroll down and select the interface 1/0/4 check box.
Now 1/0/4 appears in the Interface field at the top.
• In the OSPF Area ID field, enter 0.0.0.2.
• In the OSPF Admin Mode field, select the Enable.
• In the Priority field, enter 255.
• In the Metric Cost field, enter 64.
c. Click Apply to save the settings.
Stub Areas
The example is shown as CLI commands and as a Web interface procedure.
Port 2/0/11
Port 2/0/191
Port 1/0/151
Layer 3
switch
Area 0 Area 1
Layer 3
switch
Figure 10. Area 1 is a stub area