NETGEAR GSM7228PS - Stack Switches Using 10 G Fiber

Chapter 18. Switch Stacks | 311
ProSafe 7000 Managed Switch Release 8.0.3
a. Select System > Stacking > Advanced > Stack Port Configuration. A screen
similar to the following displays.
b. Under Stack Port Configuration, scroll down and select the 1/0/51 check box.
c. In the Configured Stack Mode list, select Ethernet.
d. Click Apply to save the settings.
4. Reboot the switch.
a. Select Maintenance > Reset > Device Reboot. A screen similar to the following
displays.
b. In the Reboot Unit No. list, select 1 .
c. Click Apply.
Stack Switches Using 10G Fiber
This example shows how to stack two switches in different buildings at long distance using
10G fiber. First insert AX741 to I/O slot on Switch A, and insert AX741 to I/O slot on Switch B.
Then connect the two AX741 with fiber.
Switch A
AX741
Ax741
Switch B
Figure 35. Using 10G fiber to stack switches in different buildings