Chapter 17. Syslog | 295
ProSafe 7000 Managed Switch Release 8.0.3
Show Logging
The example is shown as CLI commands and as a Web interface procedure.
CLI: Show Logging
(Netgear Switch Routing) #show logging
Logging Client Local Port : 514
CLI Command Logging : disabled
Console Logging : disabled
Console Logging Severity Filter : alert
Buffered Logging : enabled
Syslog Logging : enabled
Log Messages Received : 66
Log Messages Dropped : 0
Log Messages Relayed : 0
Log Messages Ignored : 0
Web Interface: Show Logging
1. Configure the syslog.
a. From the main menu, select Monitoring > Logs > Sys Log Configuration.
b. In the Syslog Configuration, next to the Admin Status, select the Enable radio
button.
c. Click Apply.
2. Configure the command log.
To Next Page
Loading...
