434 | Chapter 27. DHCP L2 Relay and L3 Relay
ProSafe 7000 Managed Switch Release 8.0.3
Note: Do not fill in the Network Mask field and Network Prefix Length field
at the same time.
c. Click Add. The pool_dynamic name is now added to the Pool Name drop-down list.
Confige a DHCP L3 Relay
CLI: Configure a DHCP L3 Relay
1. Enable routing on the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#
2. Create a routing interface and enable RIP on it.
(Netgear Switch) (Config)#
(Netgear Switch) (Config)#interface 1/0/4
(Netgear Switch) (Interface 1/0/4)#routing
(Netgear Switch) (Interface 1/0/4)#ip address 10.100.1.2 255.255.255.0
(Netgear Switch) (Interface 1/0/4)#ip rip
(Netgear Switch) (Interface 1/0/4)#exit
3. Create a routing interface connecting to the client.
(Netgear Switch) (Config)#interface 1/0/15
(Netgear Switch) (Interface 1/0/15)#routing
(Netgear Switch) (Interface 1/0/15)#ip address 10.200.1.1 255.255.255.0
(Netgear Switch) (Interface 1/0/15)#exit
4. Configure the DHCP Server IP address and enable the DHCP L3 relay.
(Netgear Switch) (Config)#ip helper-address 10.100.1.1 dhcp
(Netgear Switch) (Config)#ip helper enable
To Next Page
Loading...
