290 | Chapter 16. Tools
ProSafe 7000 Managed Switch Release 8.0.3
a. Select Maintenance > File Management > Dual Image Configuration. A screen
similar to the following displays.
b. Under Dual Image Configuration, scroll down and select the Image 2 check box. The
image2 now appears in the Image name field at the top.
c. In the Active Image field, select TRUE.
d. Click Apply.
Outbound Telnet
In this section, the following examples are provided:
• CLI: show network on page 291
• CLI: transport output telnet on page 292
• Web Interface: Configure Telnet on page 292
• CLI: Configure the session-limit and session-timeout on page 293
• Web Interface: Configure the Session Timeout on page 293
Outbound Telnet:
• Establishes an outbound Telnet connection between a device and a remote host.
• A Telnet connection is initiated, each side of the connection is assumed to originate and
terminate at a network virtual terminal (NVT).
• Server and user hosts do not maintain information about the characteristics of each
other’s terminals and terminal handling conventions.
• Must use a valid IP address.
To Next Page
Loading...
