108 | Chapter 9. VRRP
ProSafe 7000 Managed Switch Release 8.0.3
a. Select Routing > VRRP > Advanced > VRRP Configuration. A screen similar to the
following displays.
b. Under Global Configuration, next to the Admin Mode, select Enable radio button.
c. Enter the following information in the VRRP Configuration:
• In the VRID (1 to 255) field, enter 20.
• In the Interface field, select 1/0/2.
• In the Primary IP Address field, enter 192.150.2.1.
• In the Mode field, select Active.
d. Click Apply to save the settings.
VRRP on a Backup Router
The example is shown as CLI commands and as a Web interface procedure.
CLI: Configure VRRP on a Backup Router
1. Enable routing for the switch. IP forwarding will then be enabled by default.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
2. Configure the IP addresses and subnet masks for the port that will participate in the protocol.
(Netgear Switch) (Config)#interface 1/0/4
(Netgear Switch) (Interface 1/0/4)#routing
(Netgear Switch) (Interface 1/0/4)#ip address 192.150.4.1 255.255.0.0
(Netgear Switch) (Interface 1/0/4)#exit
To Next Page
Loading...
