NETGEAR GSM7228PS - Chapter 25 Ipv6 Interface Configuration; Create an Ipv6 Routing Interface

Chapter 25. IPv6 Interface Configuration | 364
25
25. IPv6 Interface Configuration
This chapter provides the following examples:
• Create an IPv6 Routing Interface
• Create an IPv6 Routing VLAN on page 368
Create an IPv6 Routing Interface
The example is shown as CLI commands and as a Web interface procedure.
CLI: Create an IPv6 Routing Interface
1. Enable IPV6 forwarding and unicast routing on the switch.
(Netgear Switch) (Config)#ipv6 forwarding
(Netgear Switch) (Config)#ipv6 unicast-routing
2. Assign an IPv6 address to interface 1/0/1.
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#ipv6 enable
(Netgear Switch) (Interface 1/0/1)#ipv6 address 2000::2/64
(Netgear Switch) (Interface 1/0/1)#routing
(Netgear Switch) (Interface 1/0/1)#exit
(Netgear Switch) #ping ipv6 2000::2
Send count=3, Receive count=3 from 2000::2
Average round trip time = 1.00 ms
(Netgear Switch) #show ipv6 brief
IPv6 Forwarding Mode........................... Enable
IPv6 Unicast Routing Mode...................... Enable
IPv6 Hop Limit................................. 0
ICMPv6 Rate Limit Error Interval............... 1000 msec
ICMPv6 Rate Limit Burst Size................... 100 messages
Maximum Routes................................. 12