Chapter 24. Tunnel | 363
ProSafe 7000 Managed Switch Release 8.0.3
a. Select Routing > IPv6 > Advanced > Tunnel Configuration. A screen similar to the
following displays.
b. In the Tunnel Id list, select 0.
c. In the Mode list, select 6-in-4-configured.
d. In the Source Address field, enter 192.168.1.2.
e. In the Destination Address field, enter 192.168.1.1.
f. Click Apply.
5. Assign an IPv6 address to the tunnel.
a. Select Routing > IPv6 > Advanced > Prefix Configuration. A screen similar to the
following displays.
b. In the Interface list, select 0/7/1.
c. In the IPv6 Prefix field, enter 2000::2.
d. In the Length field, enter 64.
e. In the EUI64 field, select Disable.
f. Click Add.
To Next Page
Loading...
