362 | Chapter 24. Tunnel
ProSafe 7000 Managed Switch Release 8.0.3
a. Select Routing > IPv6 > Basic > Global Configuration. A screen similar to the
following displays.
b. For IPv6 Unicast Routing, select the Enable radio button.
c. For IPv6 Forwarding, select the Enable radio button.
d. Click Apply.
3. Create a routing interface and assign an IP address to it.
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Under IP Interface Configuration, scroll down and select the Port 1/0/13 check box.
Now 1/0/1 appears in the Port field at the top.
• In the IP Address field, enter 192.168.1.2.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
c. Click Apply.
4. Create a 6-in-4 tunnel interface.
To Next Page
Loading...
