Chapter 10. ACLs | 157
ProSafe 7000 Managed Switch Release 8.0.3
d. Select the check box below Port 1.
e. Click Apply. At the end of this configuration a screen similar to the following
displays.
Configure IPv6 ACLs
This feature extends the existing IPv4 ACL by providing support for IPv6 packet
classification. Each ACL is a set of up to 12 rules applied to inbound traffic. Each rule
specifies whether the contents of a given field should be used to permit or deny access to the
network, and can apply to one or more of the following fields within a packet:
• Source IPv6 prefix
• Destination IPv6 prefix
• Protocol number
• Source Layer 4 port
• Destination Layer 4 port
• DSCP value
• Flow label
To Next Page
Loading...
