Chapter 16. Tools | 280
16
16. Tools
This chapter provides the following examples:
• Traceroute
• Configuration Scripting on page 282
• Pre-Login Banner on page 285
• Port Mirroring on page 286
• Dual Image on page 287
• Outbound Telnet on page 290
Traceroute
This section describes the traceroute feature. Use traceroute to discover routes that packets
take when traveling on a hop-by-hop basis to their destination through the network.
• Tracerout maps network routes by sending packets with small time-to-live (TTL) values
and watches the ICMP time-out announcements.
• The tracerout command displays all L3 devices.
• It can be used to detect issues on the network .
• Tracerout tracks up to 20 hops.
• The default UPD port is used 33343 unless you specify otherwise in the traceroute
command.
The following shows an example of using the traceroute command to determine how
many hops there are to the destination. The command output shows each IP address the
packet passes through and how long it takes to get there. In this example, the packet takes
16 hops to reach its destination.
To Next Page
Loading...
