NETGEAR GSM7228PS - Chapter 10 Acls; Access Control Lists

Chapter 10. ACLs | 111
10
10. ACLs
Access Control Lists
This chapter describes the Access Control Lists (ACLs) feature. The following examples are
provided:
• MAC ACLs on page 112
• Set Up an IP ACL with Two Rules on page 113
• One-Way Access Using a TCP Flag in an ACL on page 117
• Use ACLs to Configure Isolated VLANs on a Layer 3 Switch on page 132
• Set up a MAC ACL with Two Rules on page 144
• ACL Mirroring on page 147
• ACL Redirect on page 152
• Configure IPv6 ACLs on page 157
Access control lists (ACLs) can control the traffic entering a network. Normally ACLs reside in a
firewall router or in a router connecting two internal networks. When you configure ACLs, you
can selectively admit or reject inbound traffic, thereby controlling access to your network or to
specific resources on your network.
You can set up ACLs to control traffic at Layer 2-, or Layer 3. MAC ACLs are used for Layer 2. IP
ACLs are used for Layer 3. Each ACL contains a set of rules that apply to inbound traffic. Each
rule specifies whether the contents of a given field should be used to permit or deny access to
the network, and may apply to one or more of the fields within a packet.
The following limitations apply to ACLs. These limitations are platform dependent.
• The maximum of number of ACLs is 100.
• The maximum number of rules per ACL is 8–10.
• Stacking systems do not support redirection.
• The system does not support MAC ACLs and IP ACLs on the same interface.
• The system supports ACLs set up for inbound traffic only.