NETGEAR GSM7228PS - Configure Traffic Shaping

Chapter 11. CoS Queuing | 171
ProSafe 7000 Managed Switch Release 8.0.3
CLI: Set CoS Trust Mode for an Interface
(Netgear Switch) (Interface 1/0/3)#classofservice trust?
dot1p Sets the Class of Service Trust Mode of an Interface
to 802.1p.
ip-dscp Sets the Class of Service Trust Mode of an Interface
to IP DSCP.
(Netgear Switch) (Interface 1/0/3)#classofservice trust dot1p?
<cr> Press Enter to execute the command.
(Netgear Switch) (Interface 1/0/3)#classofservice trust dot1p
Note: The traffic class value range is 0–-6 instead of 0–-7 because queue
7 is reserved in a stacking build for stack control, and therefore you
cannot configure it.
Web Interface: Set CoS Trust Mode for an Interface
1. Select QoS > CoS > Advanced > CoS Configuration. A screen similar to the following
displays.
2. Under CoS Configuration, select the Interface radio button.
3. In the Interface list, select 1/0/3.
4. In the Interface Trust Mode list, select trust dot1p.
5. Click Apply to save the settings.
Configure Traffic Shaping
Traffic shaping controls the amount and volume of traffic transmitted through a network. This
has the effect of smoothing temporary traffic bursts over time. Use the traffic-shape