NETGEAR GSM7228PS - Set Cos Trust Mode for an Interface

170 | Chapter 11. CoS Queuing
ProSafe 7000 Managed Switch Release 8.0.3
c. Under Interface Queue Configuration, scroll down and select the interface 1/0/2
check box. Now 1/0/2 appears in the Interface field at the top.
d. Enter the following information:
• In the Minimum Bandwidth field, enter 15.
• In the Scheduler Type list, select Weighted.
e. Click Apply to save the settings.
2. For interface 1/0/2, set the minimum bandwidth 25 for queue 1, and set the scheduler type
to strict.
a. Select QoS > CoS > Advanced > Interface Queue Configuration. A screen similar
to the following displays.
b. In the Queue ID list, select 1.
c. Under Interface Queue Configuration, scroll down and select the interface 1/0/2
check box. Now 1/0/2 appears in the Interface field at the top.
d. Enter the following information:
• In the Minimum Bandwidth field, enter 25.
• In the Scheduler Type list, select Strict.
e. Click Apply to save the settings.
Set CoS Trust Mode for an Interface
The example is shown as CLI commands and as a Web interface procedure.