Chapter 17. Syslog | 299
ProSafe 7000 Managed Switch Release 8.0.3
Select Monitoring > Logs > Trap Logs. A screen similar to the following displays.
Show Logging Hosts
The example is shown as CLI commands and as a Web interface procedure.
CLI: Show Logging Hosts
(Netgear Switch Routing) #show logging hosts ?
<cr> Press Enter to execute the command.
(Netgear Switch Routing) #show logging hosts
Index IP Address Severity Port Status
----- ----------------- ---------- ---- -------------
1 192.168.21.253 critical 514 Active
To Next Page
Loading...
