NETGEAR GSM7228PS - Convert the Dynamic Address Learned from 1;0;1 to a Static Address

Chapter 14. Security Management | 229
ProSafe 7000 Managed Switch Release 8.0.3
Convert the Dynamic Address Learned from 1/0/1 to a
Static Address
The example is shown as CLI commands and as a Web interface procedure.
CLI: Convert the Dynamic Address Learned from 1/0/1 to the
Static Address
(Netgear Switch)(Interface 1/0/1)#port-security mac-address move
Convert the dynamic address learned from 1/0/1 to the static address
(Netgear Switch)(Interface 1/0/1)#exit
(Netgear Switch)(Config)#exit
(Netgear Switch)#show port-security static 1/0/1
Number of static MAC addresses configured: 3
Statically configured MAC Address VLAN ID
---------------------------------------------
00:0E:45:30:15:F3 1
00:13:46:EC:2F:62 1
00:14:6C:E8:81:23 1
Web Interface: Convert the Dynamic Address Learned from
1/0/1 to the Static Address
1. Select Security > Traffic Control > Port Security > Dynamic MAC Address. A screen
similar to the following displays.
2. Under Port Security Configuration, in the Port List field, select 1/0/1.
3. Select the Convert Dynamic Address to Static check box.
4. Click Apply to save the settings.