Subnet 2 Subnet 3 Subnet 5
Port 1/0/3
192.130.3.1
Port 1/0/5
192.64.4.1
Port 1/0/2
192.150.2.2
Layer 3 sIwitch
acting as a router
Chapter 6. RIP | 55
ProSafe 7000 Managed Switch Release 8.0.3
Figure 7. Network with RIP on ports 1/0/2 and 1/0/3
Routing for the Switch
The example is shown as CLI commands and as a Web interface procedure.
CLI: Enable Routing for the Switch
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#exit
Web Interface: Enable Routing for the Switch
1. Select Routing > IP > Basic > IP Configuration. A screen similar to the following
displays.
2. For Routing Mode, select the Enable radio button.
3. Click Apply to save the settings.
To Next Page
Loading...
