NETGEAR GSM7228PS - One-Way Access Using a TCP Flag in an ACL

Chapter 10. ACLs | 117
ProSafe 7000 Managed Switch Release 8.0.3
• In the ACL ID list, select 10.
• In the Sequence Number field, enter 1.
c. Click Unit 1. The ports display.
d. Click the gray box under port 2. A check mark displays in the box.
e. Click Apply to save the settings.
One-Way Access Using a TCP Flag in an ACL
This example shows how to set up one-way Web access using a TCP flag in an ACL. PC 1
can access FTP server 1 and FTP server 2, but PC 2 can access only FTP server 2.
FTP server 1
PC 1 PC 2
Port 1/0/25
Port 0/35
Layer 2 switch
Layer 3 switch
FTP server 2
Port 0/44
Port 1/0/48
Port 1/0/24
192.168.40.2
Port 0/13
192.168.100.2
Figure 15. One-Way Web access using a TCP flag in an ACL
CLI:Configure One-Way Access Using a TCP Flag in an ACL
This is a two-step process:
• Step 1: Configure the Switch on page 117
• Step 2: Configure the GSM7352S on page 119
Step 1: Configure the Switch
(See Figure 15, One-Way Web access using a TCP flag in an ACL.)