430 | Chapter 27. DHCP L2 Relay and L3 Relay
ProSafe 7000 Managed Switch Release 8.0.3
DHCP L3 Relay
This example shows how to configure a DHCP L3 relay on a NETGEAR switch and how to
configure DHCP pool to assign IP addresses to DHCP clients using DHCP L3 relay.
DHCP server DHCP L3 relay
PC
1/0/10 1/0/15
1/0/14
Figure 2. DHCP L3 relay
CLI: Configure a DHCP Server
1. Enable routing on the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#
To Next Page
Loading...
