Chapter 15. SNTP | 277
ProSafe 7000 Managed Switch Release 8.0.3
• Iin the Server Type field, select IPV4 .
• In the Address field, enter 208.14.208.19.
• In the Port field, enter 123.
• In the Priority field, enter 1.
• In the Version field, enter 4.
c. Click Add.
2. Configure SNTP globally.
a. Select System > Management > Time > SNTP Global Configuration. A screen
similar to the following displays.
b. Enter the following information:
• For Client Mode, Select the Unicast radio button.
• In the Time Zone Name field, enter PST.
• In the Offset Hours field, enter -8.
c. Click Apply.
Set the Time Zone (CLI Only)
The SNTP/NTP server is set to Coordinated Universal Time (UTC) by default. The following
example shows how to set the time zone to Pacific Standard Time (PST), which is 8 hours
behind GMT/UTC.
(Netgear switch)(config)#clock timezone PST -8
Set the Named SNTP Server
The example is shown as CLI commands and as a Web interface procedure.
To Next Page
Loading...
