Chapter 18. Switch Stacks | 305
ProSafe 7000 Managed Switch Release 8.0.3
joins a switch stack, its default stack member number changes to the lowest available
member number in the stack.
Stack members in the same switch stack cannot have the same stack member number.
Every stack member, including a standalone switch, retains its member number until you
manually change the number or unless the number is already being used by another member
in the stack.
See Renumber Stack Members on page 318.
Stack Member Priority Values
You can change a stack member priority. This is useful if you want to change the master of
the stack. Use the following command (in the global config mode):
switch unit priority value
Install and Power-up a Stack
Note: Many switch models such as the GSM7200PS and GSM7300S
series have a Hardware Installation Guide that includes additional
information about rack mounting and stack cabling.
Compatible Switch Models
NETGEAR stackable managed switches include the following models:
• FSM7226RS
• FSM7250RS
• FSM7328S
• FSM7328PS
• FSM7352S
• FSM7352PS
• GSM7328S
• GSM7352S
• GSM7328FS
• GSM7228PS
• GSM7252PS
The FSM family, GSM family, and XSM72224S cannot be stacked together at this point.
To Next Page
Loading...
