Chapter 20. DNS | 331
ProSafe 7000 Managed Switch Release 8.0.3
Web Interface: Specify Two DNS Servers
1. Select System > Management > DNS > DNS Configuration. A screen similar to the
following displays.
2. Under DNS Server Configuration, in the DNS Server field, enter 12.7.210.170.
3. Click Add.
4. In the DNS Server field, enter 219.141.140.10.
5. Click Add.
Both DNS servers now show in the DNS Server Configuration table.
Manually Add a Host Name and an IP Address
The following example shows commands to add a static host name entry to the switch so that
you can use this entry to resolve the IP address. The example is shown as CLI commands
and as a Web interface procedure.
CLI: Manually Add a Host Name and an IP Address
(Netgear Switch)#config
(Netgear Switch) (Config)#ip host www.netgear.com 206.82.202.46
(Netgear Switch) (Config)#ip domain-lookup
(Netgear Switch) (Config)#ping www.netgear.com
Send count=3, Receive count=3 from 206.82.202.46
To Next Page
Loading...
