NETGEAR GSM7228PS - Page 435

Chapter 27. DHCP L2 Relay and L3 Relay | 435
ProSafe 7000 Managed Switch Release 8.0.3
5. Redistribute 10.200.1.0/24 to the RIP such that RIP adviertises this route to the DHCP
server.
(Netgear Switch) (Config)#
(Netgear Switch) (Config)#router rip
(Netgear Switch) (Config-router)#redistribute connected
(Netgear Switch) (Config-router)#exit
Web Interface: Configure a DHCP L3 Relay
1. Enable routing mode on the switch.
a. Select Routing > IP > Basic > IP Configuration. A screen similar to the following
displays.
b. For Routing Mode, select the Enable radio button.
c. Click Apply.
2. Create a routing interface and assign 10.100.1.2/24 to it.
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Scroll down and select the Port 1/0/4 check box.
c. In the IP Address field, enter 10.100.1.2.
d. In the Subnet Mask field, enter 255.255.255.0.
e. In the Routing Mode field, select Enable.